Stamina 35-1681A Owner's Manual page 12

USE INSTRUCTIONS
Leveling Your Circuit Trainer Trampoline in Incline Mode
After setting your Circuit Trainer Trampoline in the INCLINED mode, check and make sure your Circuit
Trainer Trampoline sits on the floor without rocking. If it is rocking, please see the following steps to
level your Circuit Trainer Trampoline.
STEP 1:
Refer to illustration R5. Push the rail frame and hold it down at the position between the two short
legs. Verify which LONG HOOKED LEG(9) does not touch the floor and causes rocking.
STEP 2:
Refer to the detail view. Put the ADJUSTMENT WASHERS(30) under the LONG HOOKED
LEG(9) that does not touch the floor to verify how many ADJUSTMENT WASHERS(30) are needed for
the leveling adjustment.
STEP 3:
Refer to illustration R6. Remove the DOME CAP(11) from the LONG HOOKED LEG(9). Put the
needed ADJUSTMENT WASHERS(30) into the DOME CAP(11). Press the DOME CAP(11) back on the
LONG HOOKED LEG(9).
R5
Short Legs
Adjustment
Washers(30)
12
R6
Adjustment
Washers(30)