Assembly Instructions - Stamina 35-1681A Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Customer Care section and order the part
needed, e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520
(in the U.S.). Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
Some product parts are fit tested at the factory to ensure proper fit and alignment. Marks in
the paint may be noticeable, but are not an indication of damage.
WARNING
!
1. ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE CIRCUIT
TRAINER TRAMPOLINE. FAILURE TO USE TWO OR MORE STRONG PEOPLE MAY
ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND STRIKE
SOMEONE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
2. Keep children away from the Circuit Trainer Trampoline during assembly.
3. Keep fingers away from the ends of the rails in the hinge area when unfolding the Circuit
Trainer Trampoline. The Circuit Trainer Trampoline will snap into the unfolded position.
Serious injury can occur if fingers are caught between the ends of the RAILS.
4. The SAFETY PAD(6) must be installed before using the Circuit Trainer Trampoline.
NOTE :
BEFORE
assembly, verify that the SECURE
PINS(14) are properly inserted into the Frame
Rail on both sides. The two protrusions must be
assembled inside the Frame Rail as shown in the
SECTION VIEW of the illustration. Otherwise,
it could damage the SECURE PINS(14) during
Assembly Step 2.
STEP 1
Lay the trampoline on the floor. The trampoline will appear as shown in illustration 1.
1.
7
SECTION VIEW
Secure Pin
Secure Pin
Frame Rail