Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 4
Refer to illustration 5. To install the SAFETY PAD(6), first, slide the SAFETY PAD(6) over the two HOOKED
LEGS(8), make the HOOKED LEGS(8) completely go through the holes in the SAFETY PAD(6). Second,
install the SAFETY PAD(6) on to Threaded Connector B. Third, slide the SAFETY PAD(6) over the rail
frame, make the holes in SAFETY PAD(6) fit over Threaded Connectors A, C, and D.
HINT : After sliding the SAFETY PAD(6) over the two HOOKED LEGS(8), the next hole installed should
be on the connector on the opposite side of the trampoline.
CAUTION: The SAFETY PAD(6) must be securely attached to the rail frame in the correct position. All six
(6) holes in the SAFETY PAD(6) must fit over the two HOOKED LEGS(8) and the four Threaded
Connector A, B, C, and D on the rail frame as shown in illustration 6. The SAFETY PAD(6) must
also cover the elastic bands on the MAT(5) as shown in illustration 8 on the following page.
STEP 5
Refer to illustration 6. Press the LEG CAPS(12) onto the HOOKED LEGS(8).
5.
FIRST STEP:
Install the Safety Pad(6)
on to this Threaded
Connector.
A
STEP 6
Refer to the position of the legs as shown in illustration
7. First, screw the two LEGS(7) with DOME CAPS(11)
and Warning Labels on sides opposite from each other.
Next, attach the LEGS(7) with LEG CAPS(12) into the
threaded connectors on the rail frame.
D
C
SECOND STEP:
B
Install the Safety Pad(6) on
to this Threaded Connector.
Warning
Label
9
6.
7.
Warning
Label
Advertisement
Table of Contents
