Table of Contents
Advertisement
5. Have a second person hold the Console (101)
near the handrail assembly.
Connect the Upright Wire (111) and the handrail
wires to the console wires. Make sure that the
console wire and the handrail wire that you are
connecting have connectors that are the same
size. See the lower drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
then try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Insert the excess wires downward into the
Upright Cover (80).
Set the Console (101) on the handrail assembly.
Be careful not to pinch any wires.
6. Align the holes in the Console (101) with the
holes in the handrail assembly and the holes in
the Upright (not shown). Attach the Console and
the handrail assembly to the Upright with two
3/8" x 3 1/4" Patch Bolts (1) and two 3/8" Star
Washers (2). Do not fully tighten the Patch
Bolts yet. Note: It may be helpful to press the
indicated bracket against the Upright (81)
and to press down on the Console to align
the holes.
5
Console
Wires
Handrail
Wires
111
Console
Wire
6
101
1
2
Bracket
9
101
Handrail
Wire
Handrail
80
Assembly
111
Handrail
81
Assembly
Advertisement
Table of Contents
