Adjusting The Handle Height - Toro 30441 Operator's Manual

Figure 25
1. Gage Wheels
2. Nut
Figure 26
1. Gage Wheels
2. Nut
3. Bolt
Figure 27
1. Center Gage Wheels and
spacer
2. Nut
3. Washer
4. Washer
5. Spacer
3. Bolt
4. Washer

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter pins and clevis
pins from the drive levers and neutral locks
(Figure 28).
Figure 28
1. Control rod
2. Clevis pin
3. Drive lever
4. Operator Presence Control
lever (OPC)
2. Loosen the nuts holding the swivel connected
to the speed control crank (Figure 29).
31
5. Left handle shown
6. Neutral lock
7. Hairpin cotter pin