Toro 30441 Operator's Manual page 22

Ignition Switch
This switch is used in conjunction with recoil
starter and has two positions: Run and Off.
Speed Control Lever
This machine has a variable speed control with
a neutral position. This controls how fast the
machine will travel forward.
Drive Levers
Release drive levers to engage forward traction
operation and squeeze the levers until an increase
in force is felt to go into neutral position and
continue to squeeze to go in reverse. Squeeze
right side of drive lever to turn right and left side
to turn left.
Neutral Lock
Squeeze drive levers back until an increase in force
is felt and move locks to the rear for neutral lock.
Fuel Shut-off Valve
Close the fuel shut-off valve (under fuel tank )
when transporting or storing mower.
Hour Meter
Shows the total hours the machine has been
operated. This operates only when the mower
blades are operating.
The hour meter will flash 3 hours before and after
a service interval. The service intervals are set for
the first 8 hours, every 100 hours there after, and
every 400 hours.
Note: Make sure maintenance is done at
all recommended intervals shown in the
Recommended Maintenance Schedule.
22