Adjusting The Handle Height - Toro 30686 Operator's Manual

Figure 16

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter pins and clevis pins from
the drive levers and neutral locks (Figure 17).
1. Control rod
2. Clevis pin
3. Operator Presence
Control lever (OPC)
4. Handle
2. Loosen the upper bolts (3/8 x 1-1/4 inch) and
flange nut securing handle to rear frame (Figure 18).
3. Remove the lower bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Figure 18).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and flange
nuts into mounting holes. Tighten all flange bolts.
1. Upper handle
2. Rear frame
3. Flange bolt (3/8 x 1 inch)
4. Lock nut (3/8 inch)
5. Upper mounting hole
22
Figure 17
5. Neutral lock
6. Hairpin cotter pin
7. Left handle shown
8. Drive lever
Figure 18
6. Lower mounting holes
7. Low position
8. Middle position
9. High position