Install The Speed Control; Installing The Hairpin Cotter Pins; And Spacers - Toro 30441 Operator's Manual

Step
5

Install the Speed Control

Rod
Parts needed for this step:
1 Washer
1 Cotter pin
Procedure
Install the swivel into the speed control crank and
secure it with a washer and cotter pin (Figure 10 ).
Note: If necessary, move the speed control lever
until the swivel will go into the speed control
crank.
Figure 10
1. Speed control rod
2. Swivel
3. Nut
4. Speed control crank
5. Cotter pin
6. Washer
Step
6
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
2 Hairpin cotter pin
6 Spacers
Procedure
Store unused height-of-cut spacers on posts and
retain them by a hairpin cotter.
Note: Make sure there is at least one spacer used
on each height-of-cut post.
1. Remove the existing rear hairpin cotter pins
from the rear height-of-cut posts (Figure 11).
2. Install a spacer onto both rear height-of-cut
posts and install the hairpin cotter pins
(Figure 11).
Figure 11
1. Hairpin cotter
2. Spacer
3. Install a spacer onto both front height-of-cut
posts and install the hairpin cotter pins.
4. On the opposite side of the muffler,
install unused spacers onto front and rear
height-of-cut pins and insert the hairpin cotter
pins (Figure 12).
17
3. Height-of-cut post (rear
shown)