Toro 30441 Operator's Manual page 32

Figure 29
1. Speed control rod
2. Swivel
3. Loosen the upper flange bolts (3/8 x 1-1/4
inches) and flange nut securing handle to rear
frame (Figure 30).
4. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 30).
5. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and
flange nuts into mounting holes. Tighten all
flange bolts.
3. Nut
Figure 30
1. Control rod tting
2. Lower mounting holes
3. Rear frame
4. Lower ange bolt (3/8 x 1
inch)
5. Upper ange bolt (3/8 x
1-1/4 inches)
6. High position
6. Adjust the swivel on the speed control rod and
tighten the nuts against the swivel (Figure 29).
7. Adjust the control rod length by rotating the
control rod in the rod fitting (Figure 29).
8. Install hairpin cotter between drive levers and
neutral locks and into clevis pins (Figure 28).
Note: Make sure the clevis pins are inserted
into the neutral locks.
9. Perform the hydraulic linkage adjustments
when the handle height is changed; refer
Hydraulic Linkage Adjustments.
32
7. Lower position
8. Upper mounting hole
9. Handle
10. Flange nut (3/8 inch)
11.