Installing The Control Rods; Rod - Toro 30441 Operator's Manual

Figure 7
1. Bolt (5/8 x 7/8 inch)
2. Washer (5/8 inch)
3. Lock washer (5/8 inch)
4. Spring
Step
4

Installing the Control Rods

Parts needed for this step:
2 Control rods
2
E-ring
Procedure
1. For a starting point, make sure the rod fittings
are threaded approximately 2-1/2 inches (63
mm) onto the control rods (Figure 8)..
2. Install the control rod fittings into the control
arm and secure them with E-rings (Figure 8).
5. Locknut
6. Hose clamp
7. Fuel tank connection
Figure 8
1. Control rod
2. Rod tting
3. 2–1/2 inch (63.5 mm) from
the bottom
3. Place the clevis pin into the control rod, drive
lever and neutral lock (Figure 9).
4. Install the hairpin cotter between the drive
levers and the neutral locks and into the clevis
pins (Figure 9).
Figure 9
1. Control rod
2. Clevis pin
3. Drive lever
4. Operator Presence Control
lever (OPC)
16
4. E-ring
5. Control arm
5. Left handle shown
6. Neutral lock
7. Hairpin cotter pin