Adjusting The Neutral Stud - Toro 30441 Operator's Manual

Mid-size pistol grip, hydro, 17hp with 52in side discharge mower

Hide thumbs Also See for 30441:

Operator's manual (64 pages)

Table Of Contents

Table of Contents

Figure 54

1. Speed control lever

2. Rear pivot spring

15. Tighten the front nut on left hydro control

linkage shown in Figure 53.

Adjusting the Right Side Linkage

1. With the machine on jack stands, place the

speed control lever in the neutral position.

2. Place the right drive lever in the full forward

position.

3. Hold the OPC levers down.

Note: The OPC levers must be held down

whenever the speed control lever is out of the

neutral position or the engine will kill.

4. Adjust the right side linkage by turning the

quick track knob counterclockwise until the

tire begins to rotate forward (Figure 55).

5. Turn the knob clockwise a 1/4 of a turn at a

time. Then move the speed control forward

and back to neutral. Repeat this until right

wheel stops rotating forward (Figure 55).

6. The spring that keeps tension on the knob

should normally not need adjustment.

However if an adjustment is needed, adjust the

length of spring to 1 inch (26 mm) between

the washers (Figure 55).

7. Adjust the spring length by turning the nut at

the front of spring (Figure 55).

8. After adjusting the right hydro control linkage,

move the speed control lever forward and then

back to the neutral position.

9. Make sure the speed control lever is in the

neutral position and the tire does not rotate.

10. Repeat adjustment if needed.

3. spring

Figure 55

1. Hydro control linkage

2. Quick track knob

3. Spring