Checking The Hydraulic Fluid And Engine Oil Level; Setting Up The Hydro; Linkage - Toro 30441 Operator's Manual

Figure 13
1. Fill caps
2. Upper line
6. Install the battery fill caps (Figure 13).
Charging the battery produces gasses
that can explode and cause serious injury.
• Keep cigarettes, sparks and flames
away from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the
battery in an enclosed space.
7. Make sure the vent caps are installed in the
battery. Charge the battery. Refer to Charging
the Battery.
8. Install the battery in the machine and connect
the battery cables. Refer to Installing the
Battery.
Important: Do not run the machine
with the battery disconnected; electrical
damage may occur to the engine.
Step
8
Checking the Hydraulic
Fluid and Engine Oil Level
No Parts Required
Procedure
Before you start the engine do the following:
3. Lower line
• check the oil level in the engine crankcase;
refer to Checking the Engine Oil Level.
• check the hydraulic fluid level in the engine
crankcase; refer to Checking Hydraulic the
Fluid Level.
Step
9

Setting Up the Hydro

Linkage

No Parts Required
Procedure
Check the following adjustments when the
machine is first set up and adjust only as needed.
Do them in the order that they are listed here.
1. Check the speed control linkage; refer to
Adjusting the Speed Control Linkage.
2. Check the temporary neutral stud adjustment;
refer to Temporary Neutral Stud Adjustment
3. Check the hydro control linkages; refer to
Adjusting the Hydro Control Linkages.
4. Check the neutral stud; refer to Adjusting the
Neutral Stud.
5. Check the control rods; refer to Adjusting the
Control Rods.
6. Checking the tracking; refer to Adjusting the
Tracking.
19