Setup - Toro 30441 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
Handle assembly
Flanged bolt (3/8 x 1 inch)
2
Flanged bolt (3/8 x 1-1/4 inches)
Flange nut (3/8 inch)
Fuel tank with studs installed
Bolt (5/16 x 7/8 inch)
Lock nut (5/16 inch)
3
Washer (5/16 inch)
Hose clamp
Lock washer (5/16 inch)
Spring
Control rods
4
E-ring
Washer
5
Cotter pin
Hairpin cotter pin
6
Spacers
7
No parts required
8
No parts required
9
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
10
Safety Video/DVD
Registration Card
Oil drain hose
Note: Determine the left and right sides of the machine from the normal operating position.
Description
13
Qty.
Remove the shipping bracket and
–
shipping washers.
1
2
Install the handle assembly.
2
4
1
2
2
4 Install the fuel tank.
1
2
2
2
Install the control rods.
2
1
Install the speed control rod.
1
2
Install the hairpin cotter pins and
spacers.
6
–
Activate the battery.
Check the engine oil and hydraulic
–
uid level.
–
Set up the hydro linkage.
1
1
Read the Operator's Manual and
1
watch the video before operating
1
the machine.
1
1
Use