Adjusting The Handle Height - Toro 38096 Operator's Manual

1. After adjusting the height-of-cut, check the
anti-scalp rollers so that there is a minimum of 3/8
inch (10 mm) clearance above the ground (Figure 13
and Figure 14).
2. If adjustment is needed, remove the bolt, washers
and nut (Figure 13 and Figure 14).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 13 and Figure 14).
4. Install the bolt and nut (Figure 13, Figure 14,
@@@5).
Figure 13
1. Mower deck
2. Bolt
3. Spacer
4. Anti-scalp rollers
5. Nut
1. Mower deck
2. Bolt
3. Spacer
5. In certain mowing conditions and terrain, a
mismatch of cutting height may be seen. Adjusting
the outside anti-scalp rollers to the minimum setting
of 3/8 inch (10 mm) will help prevent the mower
deck cutting too low on the outside and minimize
the mismatch.

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter, washer and clevis pin
securing control rod fitting to the idler bracket
(Figure 15).
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
18
Figure 14
4. Bushing
5. Anti-scalp rollers
6. Nut
Figure 15
4. Washer
5. Hairpin cotter
6. Rod fitting