Table of Contents
Advertisement
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
Removing the Battery
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to
touch any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the machine.
Incorrect battery cable routing could
damage the machine and cables causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• Always Disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always Reconnect the positive (red)
battery cable before reconnecting the
negative (black) cable.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Lift the black rubber cover on the negative
cable. Disconnect the negative battery
cable from the negative (-) battery terminal
(Figure 44).
4. Slide the red terminal boot off the positive
(red) battery terminal. Then remove the
positive (red) battery cable (Figure 44).
5. Remove the battery hold down plate (Figure 44)
and remove the battery.
Installing the Battery
1. Place the batter onto the machine (Figure 44).
2. Secure the battery with the hold down plate,
j-bolts, and locknuts.
3. First, install the positive (red) battery cable to
positive (+) battery terminal with a nut, washer
and bolt (Figure 44). Slide the rubber cover
over the post.
4. Then install the negative battery cable and
ground wire to the negative (-) battery terminal
with a nut, washer and bolt (Figure 44). Slide
the rubber cover over the post.
40
Advertisement
Table of Contents
