Installing The Fuel Tank - Toro 30441 Operator's Manual

Figure 4
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Upper mounting hole
Note: Install the handle assembly before the
fuel tank.
Step
3

Installing the Fuel Tank

Parts needed for this step:
1 Fuel tank with studs installed
2 Bolt (5/16 x 7/8 inch)
2 Lock nut (5/16 inch)
4 Washer (5/16 inch)
1 Hose clamp
2 Lock washer (5/16 inch)
2 Spring
Procedure
1. Align fuel tank with the top of the rear frame
(Figure 7).
2. Push the fuel line through the grommet and
hole in the hydraulic oil filter bracket (Figure 5).
6. Lower mounting holes
7. Low position
8. High position
9. Flange bolt, 3/8 x 1–1/4
inch
1. Fuel line
2. Grommet and hole
Note: Remove the plastic cap from the fuel
fitting before installing the fuel line.
3. Push the fuel line onto the fuel tank connection
and secure it with the hose clamp that is on
the fuel line (Figure 6).
Note: To ease assembly of the fuel line to the
fuel tank connection, apply a light lubricant,
®
such as WD-40
1. Bolt, 5/16 x 7/8 inch
2. Lock washer, 5/16 inch
3. Washer, 5/16 inch
4. Secure the right side of the fuel tank to the
rear frame with 2 bolts (5/16 x 7/8 inch), lock
washers (5/16 inch) and washers (5/16 inch)
(Figure 7).
5. Secure the left side of the fuel tank to the rear
frame with washers (5/16 inch), springs and
locknuts (5/16 inch) (Figure 7).
Note: Tighten left side of the fuel tank until
it is completely tight and then unscrew the
locknut one full turn. This will allow the spring
to work.
15
Figure 5
3. Hydraulic oil lter bracket
4. Brake handle
to the end of the fuel line.
Figure 6
4. Stud
5. Spring
6. Locknut