Table of Contents
Advertisement
Adjusting the Gage Wheels
The gage wheels need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) minimum clearance above the ground.
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Figures 18 and 19).
2. If adjustment is needed, remove the bolt, washer(s) and
nut (Figures 18 and 19).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figures 18 and 19).
4. Install the bolt, washer(s) and nut (Figures 18 and 19).
2
4
1
Figure 18
1. Gage wheel
2. Nut
3. Bolt
3
4
1
Figure 19
1. Center Gage Wheels and
Spacer
2. Nut
3
5
m–6470
4. Washer
5. Spacer
4
2
m–6510
3. Bolt
4. Washer
22
Adjusting the Handle Height
The handle position can be adjusted to match the operator's
height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Fig. 20).
1
2
4
5
6
7
8
Figure 20
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 20).
3. Remove the lower flange bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Fig. 20).
4. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
6. Check the parking brake adjustment; refer to Checking
the Brakes, page 31.
3
m–6591
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
Advertisement
Table of Contents
