Connect Wire Harness
1.
Route regulator wires through J-clip on engine,
and plug in clutch and engine in-line wire
connectors (Fig. 6).
2.
Secure ground wire to one of three holes in
frame, at rear of engine, with self-tapping screw
and star washer (Fig. 6).
3.
Secure wire harness and throttle to upper handle
with cable tie (Fig. 6)
Figure 6
1. J-clip
2. Clutch wire connector
3. Engine wire connector
m–2596
4. Ground wire
5. Screw-self tapping
6. Star washer
Install Control Rods
1.
Thread rod fittings equal distance onto each
control rod. For a starting point thread on
approximately 2 in. (51 mm) (Fig. 7).
2.
Slide clevis pins through rod fittings and
mounting holes in idler brackets (from outside)
(Fig. 7). Secure with washers and hairpin cotters
(Fig. 7).
Figure 7
1. Control rod and fitting
2. 2 in. (51 mm)
3. Idler bracket
Set-Up
m–2073
4. Clevis pin, washer and
hairpin cotter
13