Install Speed Control Rod; Hydro Linkage Set Up; Activating The Battery - Toro ProLine 30341 Operator's Manual

Install Speed Control Rod

1. Place the speed control lever full forward (Fig. 5).
2. Thread yoke onto speed control rod approximately
3/4 in. (19 mm) (Fig. 5).
3. Install yoke to the speed control crank with a clevis
pin, washer and hairpin cotter (Fig. 5).
4. Secure yoke with jam nut (Fig. 5).
4
2
6
5
Figure 6
1. Speed control rod
2. Yoke
3. Jam nut
4. Speed control crank

Hydro Linkage Set Up

Perform the following adjustments when the machine is
first set up and when any adjustment is needed. Do them
in the order that they are listed here.
Adjust Speed Control Linkage
Refer to Adjusting Speed Control Linkages on page 34.
Adjust Neutral Control Linkages
Refer to Adjusting Neutral Control Linkages on page 35.
Adjust Hydro Control Linkages
Refer to Adjusting Hydro Control Linkages on page 36.
1
3
7
m–5402
5. Hair pin cotter
6. Washer
7. Clevis pin
16
Adjust Control Rods
Refer to Adjusting Control Rods on page 37.
Adjust Tracking
Refer to Adjusting Tracking on page 38.

Activating the Battery

Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the machine. Refer to
Removing the Battery on page 39.
2. Clean the top of the battery with a paper towel.
Note: Never fill the battery with electrolyte while the
battery installed in the machine. Electrolyte can be spilled
on other parts and cause corrosion.
3. Remove the vent caps from the battery (Fig. 50).
4. Slowly pour electrolyte into each battery cell until the
level is up to the "UPPER" line (Fig. 50) on the
battery case.
Important
Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe corrosion and
damage to the chassis.
5. Wait five to ten minutes after filling the battery cells.
Add electrolyte, if necessary, until the electrolyte level
is up to the "UPPER" line (Fig. 50) on the battery
case.
6. Reinstall battery filler caps.