Table of Contents
Advertisement
Step
5
Installing the Speed Control
Rod
Parts needed for this step:
Qty.
1
Washer
1
Cotter pin
Procedure
1. Install the swivel into the speed control crank and
secure it with a washer and cotter pin (Fig. 10).
Note: If necessary move the speed control lever until the
swivel will go into the speed control crank.
4
5
6
Figure 10
1. Speed control rod
2. Swivel
3. Nut
Part
1
3
2
3
m–6602
4. Speed control crank
5. Cotter pin
6. Washer
Step
6
Installing the Hairpin Cotter
Pins and Washers
Parts needed for this step:
Qty.
2
Hairpin cotter pin
Procedure
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
Note: Make sure there is at least one spacer used on
eachheight–of–cut post.
1. Remove the existing rear hairpin cotter pins from the
height–of–cut posts.
2. Install a spacer onto both rear height–of–cut posts and
install the hairpin cotter pins.
2
3
Figure 11
1. Hairpin cotter
2. Spacer
3. On the opposite side of the muffler, install unused
spacers onto front and rear height–of–cut pins and
insert the hairpin cotter pins (Fig. 12).
19
Part
1
m–7584
3. Height–of–cut post (rear
shown)
Advertisement
Table of Contents
