Table of Contents
Advertisement
ASSEMBLY
1
Place the vacuum pod onto Power nozzle.
2
Slide wand into base of the pod.
3
Insert handle into the top of the wand.
4
Attach flex hose into base of the pod.
5
Insert the crevice tool and dusting brush into the accessory clips as shown.
6
Tuck the hose between the two accessory clips.
2
1
CLICK
4
3
CLICK
5
4
CLICK
CLICK
1
Press POWER to clean bare floor surfaces, area rugs or areas above-floor. The brushroll will not spin in this mode.
UPRIGHT
2
Press POWER and BRUSHROLL to clean carpets. The brushroll indicator lights will illuminate GREEN. If there is a jam, the indicator light
CLEANING
on Power nozzle will illuminate RED. Refer to MAINTENANCE (P11) for instructions on removing blockages.
3
Place your left foot gently on the Power nozzle and tilt the handle back to start cleaning. Note: The brushroll will only spin once the
vacuum is reclined back.
ABOVE FLOOR
4
To clean with hose, press the WAND or HANDLE release button (depending on the amount of reach required) then lift handle up.
CLEANING
5
Insert wand or handle directly into desired tool.
6
Pivot back to release tool from accessory clip.
POWER
1
Bare floor or wand cleaning
6
5
OR
POWER +
BRUSHROLL
2
Carpet cleaning
OR
4
3
6
4
5
5
Advertisement
Table of Contents
