Settings; Brush-Roll Indicator Light; Cleaning Modes - Shark NZ690UK Series Instructions Manual

POWER/SURFACE SWITCH
Select surface setting:
O Power Off
I Hard Floor
For hard floors, small area rugs or
delicate carpets - the brush-roll will spin
but at a slower speed�
II Carpet
For carpets�
NOTE: Brush-Roll will continue to spin in all modes

BRUSH-ROLL INDICATOR LIGHT

INDICATOR LIGHT
WHAT DOES THE BRUSH-ROLL INDICATOR LIGHT MEAN?
Solid Green: The brush-roll is spinning and working as intended�
Solid Red: There is a jam in the brush-roll area� Turn off and unplug the vacuum and remove
any blockages in the nozzle�
Flashing Red: The motorised floor nozzle is overheating� Turn the vacuum off and wait a
minimum of 60 minutes for the unit to cool down�
10
s h a r kc l e a n . c o . u k

SETTINGS

SUCTION CONTROL
The Suction Control Slider located on the
handle allows you to adjust the suction
depending on the floor type�
MIN: to reduce suction and increase
manoeuvrability on carpets�
MAX: to increase suction on hard floors�

CLEANING MODES

UPRIGHT MODE
To engage brush-roll, step on floor nozzle
and tilt handle back firmly�
ABOVE-FLOOR—HANDLE
Press the Handle Release button and pull up on
the handle to detach it from the wand�
ACCESSORIES—HANDLE
Attach an optional cleaning accessory to
handle or wand�
NOTE: All accessories are compatible with both the wand and the handle� Included accessories
will vary by model�
LIFT AWAY MODE
Step on the pedal on the floor nozzle to lift
off the pod�
Wand
Release
ABOVE-FLOOR—WAND
Press the Wand Release button and pull up on
the wand to detach it from the pod�
ACCESSORIES—WAND
s h a r kc l e a n . c o . u k
11