Table of Contents
Advertisement
MAINTENANCE
CHECK FOR BLOCKAGES
REMOVE AND INSPECT:
1
HOSE AND TUBES
Remove Power nozzle, dustcup and hose and shine a torch in all the intake openings to check for possible blockage.
2
BOTTOM OF POWER NOZZLE
CAUTION: Nozzle contains live parts.
a
Using a coin, turn the locking screws to the unlock position and pull up to expose the airway. Remove any obstructions,
close and relock.
b
Remove any string, carpet fibers or hair that may be wrapped around the brushroll.
3
HOSE CUFF AT BASE OF POD
c
Squeeze tabs and remove hose.
d
Tilt elbow down 90°.
e
Press elbow release latch.
f
Remove elbow and check for blockages.
g
Replace elbow by inserting gasket end back into the opening and clip back into the latch.
a
a
1 2
c
b
e
TROUBLE-
Vacuum is not picking up dirt. No suction or light suction
SHOOTING
• Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum.
GUIDE
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzles and accessories for blockages; clear blockages if required.
• Close the suction release on the handle to increase suction power.
Vacuum lifts area rugs
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges. Open the suction release on the handle to
decrease suction power.
• Turn off the unit to disengage the brush roll and restart with the POWER button for suction only cleaning.
Brush roll does not spin
• Pull the handle toward you and release the Power nozzle to disengage the auto-off feature.
• Turn the unit on by pressing the BRUSHROLL button.
• Immediately turn off and unplug vacuum, disconnect the Power nozzle and remove blockage before reconnecting and turning vacuum back
on.
Vacuum turns off on its own
• This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will
automatically turn the unit off. Should this occur, perform the following steps to restart the motor thermostat:
1. Turn the unit off.
2. Unplug the vacuum.
3. Empty the dust cup and clean filters.
4. Check for blockages in hose, accessories and inlet openings.
5. Allow the unit to cool for a minimum of 45 minutes.
6. Plug in the vacuum.
7. Restart the unit on using either the POWER or BRUSHROLL buttons.
d
f
Euro-Pro, Shark, Rotator, Dust-Away and Lift-Away are trademarks of Euro-Pro
Operating LLC. All other brand names may be trademarks of their respective owners.
1 3
Advertisement
Table of Contents
