Shark Rotator NV90 Series Manual
Also See for Rotator NV90 Series:

Advertisement

Shark Rotator NV90 Series Manual

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic safety precautions should always be observed, including the following:

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1 DO NOT use outdoors or on wet surfaces.
2 Unplug from electrical outlet when not in use and before servicing.
3 DO NOT use vacuum cleaner with a damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to EURO-PRO Operating LLC for examination, repair, or adjustment.
4 DO NOT pull or carry vacuum cleaner by the cord or use the cord as a handle.
5 DO NOT unplug by pulling on cord; to unplug, grasp the plug, not the cord.
6 DO NOT handle plug or vacuum cleaner with wet hands.
7 DO NOT run the vacuum cleaner over the power cord, close a door on the cord or pull cord around sharp corners.
8 The use of an extension cord is not recommended.
9 DO NOT leave vacuum cleaner when plugged in.
10 Keep cord away from heated surfaces.
11 Turn off all controls before plugging or unplugging the vacuum cleaner.
12 Always turn off the vacuum cleaner before connecting or disconnecting motorized nozzle.
13 Store your vacuum cleaner with the power cord secured around the two cord holders - as shown in the storage instructions.

GENERAL USE
14 Use only as described in this manual.
15 DO NOT put any objects into openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
16 Keep your work area well lit.
17 Keep the vacuum cleaner moving over the carpet surface at all times to avoid damaging the carpet fibers.
18 DO NOT place vacuum cleaner on unstable surfaces such as chairs or tables.
19 DO NOT allow young children to operate the vacuum cleaner or use as a toy. Close attention is necessary when used by or near children.
20 DO NOT use without dust cup and/or filters in place.

HOSE ATTACHMENTS
21 DO NOT use if air flow is restricted; if the air paths, the hose, or the accessories become blocked, turn the vacuum cleaner off. Remove all obstructions before you turn on the unit again.
22 Keep the end of the hose and accessory openings away from face and body.
23 Keep cleaning tools and hose suction openings away from hair, face, fingers, uncovered feet, or loose clothing.
24 Only use manufacturer's recommended attachments.

DUST CUP/FILTERS/ACCESSORIES
Before turning on the vacuum:
25 Make sure that all filters are thoroughly dry after routine cleaning.
26 Make sure that dust cup and all filters are in place after routine maintenance.
27 Make sure accessories are free of blockages.
28 Only use filters and accessories provided by EURO-PRO Operating LLC.[Failure to do so will void the warranty.]

GENERAL CLEANING
29 DO NOT pick up large-sized objects.
30 DO NOT pick up hard or sharp objects such as glass, nails, screws or coins that could damage the vacuum cleaner.
31 DO NOT pick up smoking or burning objects such as hot coals, cigarette butts, or matches.
32 DO NOT pick up flammable or combustible materials such as lighter fluid, gasoline, or kerosene or use vacuum in areas where they may be present.
33 DO NOT pick up toxic solutions such as chlorine bleach, ammonia, or drain cleaner.
34 DO NOT use in an enclosed space where vapors are present from paint, paint thinner, moth-proofing substances, flammable dust or other explosive or toxic materials.
35 DO NOT vacuum up any liquids.
36 DO NOT immerse vacuum cleaner in water or other liquids.
37 DO NOT use outdoors or on wet surfaces; use only on dry surfaces.
38 Use extra care when cleaning on stairs.

POLARIZED PLUG
To reduce the risk of electric shock, this vacuum cleaner has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT force into outlet or try to modify to fit.

ASSEMBLY

  1. Place the vacuum body onto floor nozzle.
    ASSEMBLY Step 1
  2. Slide handle into top and secure with the provided bolt.
    ASSEMBLY Step 2
  3. Insert extension wand through tool caddy and over lower coupling.
    ASSEMBLY Step 3
  4. Insert the crevice tool and dusting brush into the accessory clips as shown.
    ASSEMBLY Step 4
  5. Wrap hose around lower hose clip, rest in hose cradle at top of unit and attach to wand.
    ASSEMBLY Step 5

FLOOR CLEANING

  1. Press the On/Off switch to the "I" position to vacuum bare floors or cleaning with the hose (straight suction only). The brushroll will not spin in this mode.
    FLOOR CLEANING Step 1
    POWER
    Bare floor or wand cleaning

  2. Press the On/Off switch to the "II" position to engage the motorized floor brush (for vacuuming carpets and rugs). The brushroll indicator lights will illuminate GREEN. If there is a jam, the indicator light on floor nozzle will illuminate RED. Refer to MAINTENANCE for instructions on removing blockages.
    FLOOR CLEANING Step 2
    POWER + BRUSHROLL
    Carpet cleaning
  3. Place your foot gently on the floor nozzle and tilt the handle back to start cleaning. Note: The brushroll will only spin once the vacuum is reclined back.
    FLOOR CLEANING Step 3

ABOVE FLOOR CLEANING

Remove either the end of the hose or hose with extension wand depending on the amount of reach required.
Attach desired cleaning accessory. Should you need to increase or decrease the amount of suction, refer to Helpful Tips SUCTION RELEASE.
NOTE: Select cleaning accessories are included with this model. Additional accessories are available for purchase at www.sharkclean.com or by calling 800.798.7398. For a list of what is included with this model, refer to inside flap of box.
ABOVE FLOOR CLEANING Step 1ABOVE FLOOR CLEANING Step 2

SUCTION CONTROL

1. This unit is equipped with a suction control to help with push and pull on high pile carpets, area rugs and to release suction when vacuuming delicate objects or drapery. Located at the end of the hose, slide the button forward with your thumb to minimize suction. Be sure to slide it back for maximum suction.
SUCTION CONTROL

POWER BUTTONS

2. The "I" button turns on suction only. This is ideal for use on bare floors, delicate area rugs and for use with accessories.
POWER BUTTONS Step 1
3. The "II" button spins the floor brush, ideal for use on carpeted surfaces. Note: The floor brush will only spin once the vacuum is reclined back.
POWER BUTTONS Step 2

CORD HOOK

4. For quick cord access, rotate upper hook 180° and remove cord. Rotate it back to store. Upper cord hook also pivots 90°.
CORD HOOK

HEADLIGHTS

5. Designed to illuminate debris in dark areas, the headlights illuminate any time the power is on. The headlights are long-lasting and designed to last the life of the vacuum.
HEADLIGHTS

HEIGHT ADJUSTMENT

6. This floor nozzle has been optimized to work on all types of carpets as well as bare floors so there is never any need to adjust heights for different floor surfaces.

FILTERS

7. Remember to clean your filters regularly under normal use. Also, for optimal performance, tap clean filters between washes as needed.
FILTERS

ACCESSORIES

5.5" Crevice Tool
306FFJ90
16" Crevice Tool
308FFJ90
Dusting Brush
307FFJ90
Cleans debris and dust on delicate surfaces.
Power Brush
L - 305FFJ90

Designed for removal of pet hair and ground in dirt from carpeted stairs and upholstery.
5.5” Crevice Tool 16” Crevice Tool Dusting Brush Power Brush

MAINTENANCE

EMPTY THE DUST CUP

  1. Press the dust cup release button and lift the dustcup off the vacuum.
  2. Holding the dust cup over a garbage bag or can, slide the bottom empty release latch located midway down the front of the dust cup.
  3. Press the top dust cup release latch to access and clean dust screen as required.
    EMPTY THE DUST CUP

    CLEAN THE FILTERS

    4. With the dust cup removed, remove and rinse the foam and felt filters every month. Let air dry completely before replacing. Hand wash only. Tap loose dirt off filters between washes as needed.
    5. Remove and rinse the post-motor filter frame once every year. First, remove the floor nozzle by pressing the red nozzle release button on back of vacuum. Rotate counter-clockwise to release the filter frame. Rinse the post-motor filter and let air dry completely before replacing back into the vacuum. Hand wash only. Re-assemble back on to floor nozzle.
    CLEAN THE FILTERS

    CHECK FOR BLOCKAGES REMOVE AND INSPECT:

    1. HOSE AND TUBES
    This unit is equipped with a clear cover at the top of the intake duct. Remove floor nozzle and hose and shine a flashlight up from the bottom to check for possible blockage. Remove dustcup and check all intake openings.
    HOSE AND TUBES
    2. BOTTOM OF FLOOR NOZZLE

    1. Squeeze tabs together and pull up to expose the airway.
    2. Remove any string, carpet fibers or hair that may be wrapped around the brushroll.
      BOTTOM OF FLOOR NOZZLE

TROUBLE-SHOOTING GUIDE

Vacuum is not picking up dirt. No suction or light suction

  • Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum.
  • Dust cup may be full; empty dust cup.
  • Check hose, hose connections, nozzles and accessories for blockages; clear blockages if required.
  • Close the suction release on the handle to increase suction power.

Vacuum lifts area rugs

  • Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges. Open the suction release on the handle to decrease suction power.
  • Turn off the unit to disengage the brush roll and restart with the POWER button for suction only cleaning.

Brush roll does not spin

  • Pull the handle toward you and release the floor nozzle to disengage the auto-off feature.
  • Turn the unit on by pressing the "II" button.
  • Immediately turn off and unplug vacuum, disconnect the nozzle and remove blockage before reconnecting and turning vacuum back on.

Vacuum turns off on its own

  • This vacuum cleaner is equipped with a motor protective thermostat. If for some reason your vacuum overheats, the thermostat will automatically turn the unit off. Should this occur, perform the following steps to restart the motor thermostat:

FIVE-YEAR (5) LIMITED WARRANTY

EURO-PRO Operating LLC warrants this product to be free from material defects and workmanship for a period of five (5) years from the date of purchase when utilized for normal household use, subject to the following conditions, exclusions and exceptions.
The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option.
This Limited Warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes. This Limited Warranty does not cover damage caused by misuse, abuse, negligent handling or damage due to faulty packaging or mishandling in transit. This Limited Warranty does not cover damage or defects caused by or resulting from damages from shipping or repairs, service or alteration to the product or any of its parts, which have been performed by a repair person not authorized by EURO-PRO Operating LLC.
If your appliance fails to operate properly while in use under normal household conditions within the warranty period, you may return the complete appliance and accessories with proof of purchase and date, freight prepaid. For assistance with warranty service options or customer support, please call our customer care and product specialists at 1-800-798-7398 or visit our website at www.sharkclean.com.
If the appliance is found by EURO-PRO Operating LLC to be defective, in EURO-PRO Operating LLC's sole discretion, we will repair or replace it free of charge. Proof of purchase is required and a fee of $19.95 will apply to cover the cost of return freight.*Non-durable parts including, without limitation, filters, brushes and electrical parts which normally require replacement are specifically excluded from warranty.
This Limited Warranty is extended to the original purchaser of the unit and excludes all other legal, implied and/or conventional warranties. The responsibility of EURO-PRO Operating LLC if any, is limited to the specific obligations expressly assumed by it under the terms of this Limited Warranty. In no event is EURO-PRO Operating LLC liable for incidental or consequential damages to anyone of any nature whatsoever. Some states do not permit the exclusion or limitation of incidental or consequential damages, so the above may not apply to you.
This Limited Warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province. *IMPORTANT: Carefully pack item to avoid damage in shipping. Be sure to include proof of purchase date and to attach a tag to item before packing including your name, complete address and phone number with a note giving purchase information, model number and what you believe is the problem with the item. We recommend you insure the package (as damage in shipping is not covered by your warranty). Mark the outside of your package "ATTENTION CUSTOMER SERVICE". We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.


Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Shark Rotator NV90 Series Manual

Advertisement

Need Assistance?

Do you have a question about the Rotator NV90 Series that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents