Brush Roll - Shark duo clean POWERFINS Vertex Pro ICZ300 Series Owner's Manual

MAINTENANCE
CLEANING OR REPLACING BRUSHROLLS
BRUSHROLL
TURN LOCKS LIFT COVER
If you run over a hard or sharp object or notice
a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
1. Turn off the vacuum.
2. Using a coin, turn locks counterclockwise to
open, then lift off cover to access brushroll.
3. Clear airway of blockages.
4. Replace cover by sliding tabs into slots,
then pressing down firmly on all sides. Turn
locks counterclockwise until they click securely
into place.
NOTE: The self-cleaning brushroll removes hair wrap as you clean. If any hair, string, or carpet fibers are wrapped
around the brushroll, continue cleaning to allow the self-cleaning brushroll to remove them. If some hair or fibers remain
wrapped around brushroll after continued use, open the brushroll cover on the bottom of the floor nozzle and carefully
remove them.
NOTE: To order replacement parts and filters, visit sharkclean.com.
s h a r kc l e a n . c o m
SOFT ROLLER
1. Slide Eject Roller button forward.
2. To remove Soft Roller, pull the tab on the right.
3. Tap loose debris off the Soft Roller. Use a dry
towel to wipe clean, or to remove any hair or
fibers caught in the teeth behind the Soft Roller.
4. Rinse as needed. Use ONLY lukewarm water,
and leave to air-dry completely for at least
24 hours or until completely dry.
5.
When dry, insert the left end of the roller first,
then push the right end into place with the
word Front facing forward.
MAINTENANCE
CHECKING FOR BLOCKAGES
IMPORTANT: DO NOT use sharp or metal objects to clear blockages.
Detach hose from vacuum pod,
and check opening on back of
pod for blockages.
Detach handle from wand and
hose from the vacuum pod, and
check openings for blockages.
Detach wand from floor nozzle and
remove brush roll cover. Tilt nozzle
neck back to straighten the airway,
and remove any blockages.
NOTE: Turn off vacuum and remove battery before checking for blockages
Detach dust cup from vacuum
pod. Empty dust cup, remove
debris from lint screen, and
check for blockages.
Detach wand from floor nozzle
and handle, and check both
ends of wand for blockages.
s h a r kc l e a n . c o m