Shark ROTATOR NV5000UKE Owner's Manual
  1. Manuals
  2. Brands
  3. Shark Manuals
  4. Vacuum Cleaner
  5. ROTATOR NV5000UKE
  6. Owner's manual
Shark ROTATOR NV5000UKE Owner's Manual

Shark ROTATOR NV5000UKE Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

OWNER'S GUIDE
NV500UKE
™

Advertisement

Table of Contents
loading

Related Manuals for Shark ROTATOR NV5000UKE

Summary of Contents for Shark ROTATOR NV5000UKE

  • Page 1 OWNER’S GUIDE NV500UKE ™...

  • Page 2: Technical Specifications

    THANK YOU! Thank you for purchasing the Shark Rotator Upright Vac. ® This Owner’s Guide is designed to help you get a complete understanding of your new vacuum cleaner. Please read it carefully and keep it future reference. For a list of what is included with this model, refer to inside flap of box.

  • Page 3: Important Safeguards

    READ ALL INSTRUCTIONS BEFORE USE IMPORTANT SAFEGUARDS When using an electrical appliance, basic safety precautions should 20 This appliance is not intended for use by persons (including children) with always be observed, including the following: reduced physical, sensory or mental capabilities, or lack of experience and knowledge.
  • Page 4 ASSEMBLY Place the vacuum pod onto Power nozzle. Slide wand into base of the pod. Insert handle into the top of the wand. Attach flex hose into base of the pod. Insert the crevice tool and dusting brush into the accessory clips as shown. Tuck the hose between the two accessory clips.

  • Page 5: Brush Roll

    Press POWER to clean bare floor surfaces, area rugs or areas above-floor. The brushroll will not spin in this mode. UPRIGHT Press POWER and BRUSHROLL to clean carpets. The brushroll indicator lights will illuminate GREEN. If there is a jam, the indicator light CLEANING on Power nozzle will illuminate RED.
  • Page 6 LIFT-AWAY ™ Press LIFT-AWAY to lift the pod off the power nozzle. CLEANING To clean with hose, press the WAND or HANDLE release button then lift handle up. Attach desired cleaning tool to the end of the handle or wand. Should you need to increase or decrease the amount of suction, refer to Use for portable Helpful Tips (P9), SUCTION RELEASE.
  • Page 7 CYLINDER From the Lift-Away mode, place the pod onto the cylinder caddy. ™ CLEANING Press WAND release button then lift handle up OR press HANDLE to release the handle only and attach the backsaver wand. Attach straight suction floor nozzle or other accessory. Convert your upright to a convenient Use the posts on the caddy to store additional cleaning accessories while you clean.
  • Page 8 ACCESSORIES 33 cm Flexi Crevice Tool Dusting Brush 3067FLI500 3000FC500GY NOTE: Select cleaning Extendable with rubberized end flexes to reach tight areas. Cleans hard surfaces and upholstery. accessories are included. Others are available for purchase. For a list of what is included with this model, refer to inside flap of box.
  • Page 9 For best results, ensure that the pad is flat against the bottom surface and secured tightly. ATTACHMENT & Use the Dust-Away to clean dry bare floor surfaces. Do not use to clean damp floors or wet/sticky messes. Only use pads provided by Shark , which are designed ™...

  • Page 10: Helpful Tips

    HELPFUL TIPS SUCTION CONTROL This unit is equipped with a suction control collar to help with push and pull on high pile carpets, area rugs and to release suction when dusting delicate objects or drapery. Located at base of top handle, rotate the collar 90° to minimize suction. Be sure to close again for maximum suction. POWER BUTTONS The POWER button turns on suction only.

  • Page 11: Maintenance

    MAINTENANCE EMPTY THE DUST CUP Pull up on the dust cup release latch and lift the dustcup off the pod. Holding the dust cup over a refuse bag or bin, press the bottom empty release latch. Press the top dust cup release latch to access the dust screen and remove built-up debris as required. With the dust screen removed, turn the dust cup over and empty the upper chamber by holding it by the recessed handle underneath the dust cup.
  • Page 12 CHECK FOR BLOCKAGES MAINTENANCE REMOVE AND INSPECT: HOSE AND TUBES Remove Power nozzle, dustcup and hose and shine a torch in all the intake openings to check for possible blockage. BOTTOM OF POWER NOZZLE CAUTION: Nozzle contains live parts. Using a coin, turn the locking screws to the unlock position and pull up to expose the airway. Remove any obstructions, close and relock.
  • Page 13 6. Plug in the vacuum. 7. Restart the unit on using either the POWER or BRUSHROLL buttons. Euro-Pro, Shark, Rotator, Dust-Away and Lift-Away are trademarks of Euro-Pro Operating LLC. All other brand names may be trademarks of their respective owners.
  • Page 14 NOTES...

  • Page 15: Warranty Terms And Conditions

    Once you have registered your guarantee, we may contact you using the details you have provided if needed. You can also opt to receive tips and advice on how to get the best out of your Shark machine and updates about our new Shark products and technology.
  • Page 16 Euro-Pro Europe Ltd 15 Mariner Court Calder Park Wakefield WF4 3FL Freephone 0800 862 0453 www.sharkclean.eu NV500UKE�31�IB�141211�2 Printed in China © 2014 Euro-Pro Operating LLC Illustrations may differ from actual product.

Table of Contents