Confi Guration; Plugging In And Language Selection - Roberts Stream 207 Instruction Manual

Confi guration

Plugging in and language selection

1. Place your radio on a fl at surface and plug the cable from the mains
adaptor into the DC input socket located on the left hand side of your
radio (marked 'DC') ensuring that the plug is pushed fully into the socket.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio must
remain accessible during normal use. In order to disconnect the radio
from the mains, the mains adaptor should be removed from the mains
socket outlet completely.
3. When you apply power, the display on the radio will light up and say:
'ROBERTS' and 'Stream 207'.
If this is the fi rst time that you use your radio (or a Factory Reset has
been carried out) the display will show 'Setup wizard' and 'YES' will be
highlighted on the screen.
4. By default your radio will display all menus and messages in English. If
English is your preferred language then press the Tuning/Select control
to select 'YES' and to begin setting up your radio.
If you selected 'YES', please skip to step 1 on page 11.
5. If your preferred language is not English, then rotate the Tuning/Select
control so that the 'NO' option is highlighted. Press the Tuning/Select
control to enter the selection.
Continue on the next page.
9
Setup wizard
Start now?
4,5
Setup wizard
Start now?