Procom ML100HBAHR Owner's Operation And Installation Manual page 8

Attaching Mounting Bracket To
Wall
Note: Wall anchors, mounting
screws, and spacers are in
hardware package. The hardware
package is provided with heater.
Attaching to Wall Stud Method
For attaching mounting bracket to
wall studs
1. Drill holes at marked locations
"
using 9/64 drill bit.
2. Place mounting bracket onto
wall. Line up last hole on each
end of bracket with holes drilled
in wall.
3. Insert mounting screws through
bracket and into wall studs.
4. Tighten screws until mounting
bracket is firmly fastened to
wall studs.
Attaching to Wall Anchor Method
For attaching mounting bracket to
hollow walls (wall areas between
studs) or solid walls (concrete or
masonry)
1. Drill holes at marked locations
"
using 5/16 drill bit. For solid
walls (concrete or masonry),
"
drill at least 1 deep.
2. Fold wall anchor as shown in
Figure 9 below.
Figure 9 - Folding Anchor
3. Insert wall anchor (wings
first) into hole. Tap anchor
flush to wall.
"
4. For thin walls (1/2
insert red key into wall
anchor. Push white key to
" "
pop open anchor wings
(See Figure 10).
INSTALLATION
hammer
(over 1/2
do not pop open wings.
Figure 10 - Popping Open Anchor
Wing For Thin Walls
5. Place mounting bracket onto
wall. Line up last hole on
each end of bracket with wall
anchors.
6. Insert mounting screws through
bracket and into wall anchors.
7. Tighten screws until mounting
bracket is firmly fastened to
wall.
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on
back panel of heater (see
Figure 11).
2. Place heater onto mounting
bracket. Slide horizontal slots
onto
mounting bracket.
or less),
Figure 11 - Mounting Heater Onto
Mounting Bracket
IMPORTANT: Do not
key! For thick walls
"
thick) or solid walls,
stand-out tabs on
8
Figure 12 - Installing Bottom
Mounting screw
Installing Bottom Mounting
Screw
1. Locate bottom mounting hole.
This hole is near bottom on back
panel of heater(see Figure 12).
2. Mark screw location
3. Remove heater from mounting
bracket.
4. If installing bottom mounting
screw into hollow or solid wall,
install wall anchors. Follow steps
1 t hr ough 4 under
Wall Anchor Method. If installing
bottom mounting screw into wall
stud, drill holes at marked
locations using 9/64
5. Replace heater onto mounting
bracket.
6. Place spacers between bottom
mounting holes and wall anchor
or drilled hole.
7. Hold spacer in place with
hand. With other hand, insert
mounting screw
bottom mounting hole
spacer. Place tip of screw in
opening of wall anchor or drilled
hole.
8. Tighten screw until heater is firmly
secured to wall. Do not over
tighten.
l Note: Do not replace lower front
panel at this time. Replace lower
front panel after making
connections and checking for
leaks (see page 10).
on wall.
Attaching To
"
drill bit.
one
through
and
gas