Procom ML100HBAHR Owner's Operation And Installation Manual page 7

WARNING: Maintain the
minimum clearances
i n F i g u r e 4 . I f
provide greater clearances from
floor, ceiling, and joining wall.
Figure 4 -Mounting Clearances As
Viewed From Front Of Heater
INSTALLING THERMOSTAT
SENSING BULB
For T-Stat Model Only
1. Pull out the sensing bulb from the
two clips located in the shippng
position according to the direction
as shown by the arrow. There is no
need to take out the two bulb clips.
2. Take out the bulb clip from the
hardware package and insert it into
the square hole and then insert the
sensing bulb into the bulb clip (see
Figure 5).
Figure 5 -Moving Thermostat
Sensing Bulb
INSTALLATION
FASTENING HEATER TO WALL
Mounting Bracket
shown
The mounting bracket is located
y o u c a n ,
on back panel of heater (see
Figure 6). It has been taped there
for shipping. Remove mounting
bracket from back panel.
Figure 6 -Mounting Bracket
Location
Removing Lower Front Panel Of
Heater
1. Remove two screws near bottom
corners of lower front panel.
2. Pull bottom of lower front panel
forward, then down (see Figure 7).
Figure 7 - Removing Lower Front
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end
of mounting bracket to attach
bracket
bracket to wall only in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Panel Of Heater
to wall. Attach mounting
7
Attaching to Wall Stud: This method
provides the strongest hold. Insert
mounting screws through mounting
bracket and into wall studs.
Attaching to Wall Anchor: This
method allows you
mounting bracket to hollow walls (wall
a r e a s b e t w e e n s t u d s ) o r t o
solid walls (concrete or masonry).
Decide which method better
your needs. Either method
provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall
where heater will be located.
Make sure mounting bracket is
level.
WARNING: Maintain
mum clearances shown in Fig-
ure 8. If you can, provide greater
c l e a r a n c e s f r o m
and joining wall.
2. Mark screw locations
wall. (see Figure 8)
Note: Only mark last hole on
each end of mounting bracket.
Insert mounting screws through
these holes only.
3. Remove tape and mounting
bracket from wall.
Figure 8 - Mounting Bracket
Clearances
to attach
suits
will
mini-
f l o o r
on