Procom ML100HBAHR Owner's Operation And Installation Manual page 12

ML100HBAHR
Manual Control Models
n
LIGHTING
INSTRUCTIONS
1. STOP! Read
information on the side of
heater.
2. Check that gas supply to
heater is on.
3. Push in gas control knob
slightly and turn clockwise
to the OFF position.
4. Wait five (5) minutes to clear
out any air. Then smell for
gas, including near the floor.
If you smell
" "
Follow B in
information on the side of the
heater. If you do not smell
gas, go to the next step.
5. Push in gas control knob
slightly and
counterclockwise
" "
PILOT/IGN and depress for
five(5) seconds
NOTE: The first time that the
heater is operated after connecting
the gas supply , the control knob
should be depressed for about thirty
(30) seconds. This will allow air to
bleed from the gas system.
6. With control knob pressed in,
push down and release the
ignitor button. This will light
pilot. If needed,
pressing ignitor button until
pilot lights.
7. Keep control knob depressed
for ten (10) seconds after
lighting pilot. If pilot goes out,
repeat steps 5,6 and 7.
8. To select the desired heating
level, partially press down the
control knob slightly and rotate
counterclockwise
the downward pressure on the
knob while continuing to turn until
the knob locks at the desired set-
ting position. Do not operate
between locked positions.
OPERATING YOUR HEATER
n
l Set control knob to desired
heating position.
NOTE: Both HIGH and LOW are
the safety
locked positions. You must press
in control knob before turning it
from these positions.
gas, STOP!
Figure 17 - Control Knob in The
the safety
OFF Position
turn
to
WARNING: If you do not follow
these instructions exactly, a fire
or explosion may result causing
property damage, personal injury
or loss of life.
keep
CAUTION: Do not try to adjust
heating levels by using the
equipment shutoff valve.
. Release
Figure 18 - Pilot
1 2
n
TO TURN OFFn
GAS TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the OFF position.
2. Turn off all electric power to
the appliance if service is to
be performed.
SHUTTING OFF BURNER ONLY
(PILOT STAYS LIT)
Turn control knob clockwise
to the PILOT/IGN position.
n
MANUAL LIGHTING
PROCEDURE
1. Remove lower front panel (see
Figure 7 page 7).
2. Follow steps 1
under Lighting Instructions.
3. With control knob pressed in,
strike match. Hold match to
pilot until pilot lights.
4. Keep control knob pressed in
for 30 seconds after lighting
pilot. After 30 seconds, release
control knob. Follow step 8
under Lighting Instructions.
5. Replace lower front panel.
n
through 5