Atm Setting - Planet ADE-3400 User Manual

Field
Bridge
AC-Name
Service-Name
802.1q
Apply Changes
Return
Undo

3.4.2.2 ATM Setting

Click ATM Setting in the left pane, the page shown in the following figure appears. In this
page, you can configure the p arameters of the ATM, including QoS, PCR, CDVT , SCR,
and MBS.
The following table describes the parameters of this page:
Field Description
VPI The virtual path identifier of the ATM PVC.
VCI The virtual channel identifier of the ATM PVC.
The QoS category of the PVC. Y
QoS
rt-VBR, or nrt-VBR.
Peak cell rate (PCR) is the maxi mum rate at which cells can be
PCR transmitted along a c onnection in the A TM network. It s value
ranges from 1 to 65535.
Cell delay variation tolerance
CDVT permitted between ATM cells (in microseconds). Its value ranges
from 0 to 4294967295.
Subtain cell rate (SCR) is the maximum rate that traffic can pass
SCR over a PVC without the risk of cell loss. Its value ranges from 0 to
65535.
Maximum burst size (MBS) is the maximum number of cells that
MBS
can be transmitted at the PCR. Its value ranges from 0 to 65535.
Description
idle timeout time. Within the preset minutes, if the router
does not detect the flow of
router automatically disconnects the PPPoE connection.
You can select Bridged Ethernet, Bridged PPPoE, or
Disable Bridge.
The accessed equipment type.
The service name.
You can select Disable or Enable. After enable it, you
need to ent er the VLAN ID. T he value ranges from 0 to
4095.
Click it to save the settings of this page temporarily.
Click it to return to the Channel Configuration page.
Click it to refresh this page.
33
the user continuously , the
ou can choose UBR, CBR,
(CDVT) is the amount of delay