Advance; Bridge Setting - Planet ADE-3400 User Manual

The following table describes the parameters and buttons of this page:
Field
Direction Select
WAN Setting
WAN Interface
IP Address
Services Allowed
Add
Reset

3.6 Advance

In the navi gation bar , click Advance. In th e Advance p age that is displayed cont ains
Bridge Setting, Routing, QoS, SNMP and Others.

3.6.1 Bridge Setting

Choose Advance > Bridge Setting, the page shown in the following figure appears. This
page is us ed to configure t he bridge p arameters. You can change the settings or view
some information on the bridge and its attached ports.
The following table describes the parameters and button of this page:
Field
Aging Time
802.1d Spanning Tree
Show MACs
Click Show MACs, the page shown in the following figure appears. This table shows a list
of learned MAC addresses for this bridge.
Description
Select the router interface. You can select LAN or WAN.
In this example, WAN is selected.
You can choose Interface or IP Address.
Choose the interface that permit s dat a p ackets from
WAN to access the router.
Enter the IP address on the W AN. Only the IP address
that is in the same network segment with the IP address
on the WAN can access the router.
You can choose the followi ng services from WAN: web,
telnet, ftp, tftp, snmp, or ping. You can also choose all
the services.
After setting the p arameters, c lick it to add an entry to
the Current ACL Table.
Click it to refresh this page.
Description
If the host is idle for 300 sec
value), its entry is deleted from the bridge table.
You can select Disabled or Enabled.
Select Enabled to provide p ath redundancy
while prev enting undesir able loop s in y our
network.
Click it to show a list of the learned MAC
addresses for the bridge.
43
onds (default