Atm Setting - Planet ADE-3400v4 User Manual

The following table describes the parameters and buttons of this page:
Field
Protocol
ATM VCC
Login Name
Password
Authentication
Method
Connection Type
Idle Time (s)
Bridge
AC-Name
Service-Name
802.1q
Apply Changes
Return
Undo
3 .4.2.2 ATM S etting
Click ATM Sett ing in the
page, you can configure
and M BS.
Description
It displays the protocol type used for this WAN
connection.
The ATM virtual circuit connection assigned for this PPP
interface (VPI/VCI).
The user name provided by your ISP.
The password provided by your ISP.
You can choose AUTO, CHAP, or PAP.
You can choose Continuous, Connect on Demand, or
Manual.
If choose Connect on Demand, you need to enter the
idle timeout time. Within the preset minutes, if the router
does not detect the flow of the user continuously, the
router automatically disconnects the PPPoE connection.
You can select Bridged Ethernet, Bridged PPPoE, or
Disable Bridge.
The accessed equipment type.
The service name.
You can select Disable or Enable. After enable it, you
need to enter the VLAN ID. The value ranges from 0 to
4095.
Click it to save the ettings of this page temporarily.
Click it to return to the Channel Configuration page.
Click it to refresh this page.
left pane, the page shown in the following figure appears. In
the paramete rs of the ATM, including QoS, PCR, CDVT, SCR,
36
s
this