Table of Contents
Advertisement
INSTALLATION CAUTIONS & WARNINGS
CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDOR shall not be responsible or liable in any
way for accidents or damage resulting from the use of this equipment. This system is designed to be
professionally installed in a vehicle that is in proper operating condition.
Parking brake, Transmission,
Throttle, and Engine Safety features must be in working order. It is the vehicle owner's responsibility to
understand the operating features of this system.
DO NOT INSTALL CS2005FM ALARM/REMOTE STARTER in vehicles with MANUAL TRANSMISSIONS!
There are no safety features built into this unit for manual transmission vehicles. If accidentally left in
gear, a remote started vehicle could become a self-propelled threat to life and property.
DO NOT REMOTE START A VEHICLE IN A CLOSED AREA OR GARAGE! Make sure that door is open or
there is adequate ventilation is provided. Failure to observe this rule could result in serious injury or
death from poisonous Carbon Monoxide fumes! Also note this warning when programming this system for
Cold Start operation.
BEFORE BEGINNING INSTALLATION, check all vehicle manufacturer cautions and warnings regarding
electrical service. (AIR BAGS, ABS BRAKES, AND BATTERY).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering
column, or any other moving parts in the vehicle.
DO NOT EXCEED MAXIMUM OUTPUT RATINGS - SERIOUS DAMAGE MAY OCCUR. Limits for alarm and
remote start functions are listed in the main diagram and wiring descriptions page. If you are unsure about
current load, measure the load with an AMP-METER.
REMOVE MAIN SYSTEM FUSE(S) before jump starting the vehicle. DAMAGE MAY OCCUR TO SYSTEM IF
PROPER PRECAUTIONS ARE NOT OBSERVED.
DO NOT EXTEND REMOTE START/IGNITION OUTPUT HARNESS LENGTH. Locate the control module
within reach of the supplied IGNITION/START OUTPUT wires. Extending these wires could result in poor
performance.
Advertisement
Table of Contents
