Table of Contents
Advertisement
5. Press and hold buttons (II) & (III) together for the following sequence: [2 beeps]-[3 beeps].
6. Press button (I) and the unit should emit a set of high-to-low tones and the word "OFF" will appear for 5 seconds on
the LCD screen. The alarm clock has now been cancelled.
Self-Start Timer:
1. Press and hold buttons (II) & (III) together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps]. If done
correctly, the Engine Icon will appear in the lower right corner of the LCD screen.
2. Release buttons (II) & (III).
3. Observe the time display in the top of the LCD screen and press the (II) button to set the Hour, Press the (III) button
the set minutes for any desired remote start time.
4. Press the (I) button to set and confirm the remote start time and the remote will emit a congratulation song. The
"O.K." and Engine Icons will display indicating the remote start timer has set. Note: The Remote Start Timer
activates once for each setting. Vehicle must be within range of the remote control! Follow steps 1, 2, and 3
to reset timer for a new time or follow steps 1 & 3 only to set the timer for the same time again.
To Cancel Self-Start timer:
5. Press and hold buttons (II) & (III) together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps].
6. Release Buttons (II) & (III)
7. Press button (I) and the unit should emit a set of high-to-low tones and the word "OFF" will appear for 5 seconds on
the LCD screen. The remote start timer has now been cancelled and the OK/Engine icons will disappear.
Silent Arm/Disarm (Chirp Cancel):
1. Press and hold buttons (II) & (III) together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps]-[4-beeps]. If
done correctly, the word "CHIRP" appears on the LCD screen.
2. Press the (I) button to set this option and cancel chirps. A silent Icon will flash once on the LCD screen and lights
will flash once on the vehicle. The CS2006FM system will now arm and disarm without siren chirps.
To cancel Silent Arm/Disarm (Re-enable Chirps):
Follow step 1 above. The unit will automatically switch out of silent mode. The siren will chirp once and flash
the lights once indicating chirps are enabled again.
Canceling Remote Tones:
1. Press and hold buttons (II) & (III) together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps]-[4 beeps]-[5
beeps]. If done correctly, the word "SOUND" appears on the LCD screen.
2. The word "OFF" will then appear automatically and the remote's LED will flash 5 times. The remote will no longer
emit ANY confirmation/paging tones. (Remote still beeps when buttons are pressed, however paging tones, alerts,
and melodies will be silent.)
CLOCK / TIMED FEATURE OPERATION
Advertisement
Table of Contents
