Table of Contents
Advertisement
6. Valet mode inhibits the alarm, remote start, and in-car page/call features.
TRANSCEIVER REMOTE CONTROL PROGRAMMING
The supplied 2-Way Pager/Remote-Transceiver(s) is programmed from the factory to operate the system. In
the event you need to add another transmitter, or reprogram any transmitter to the system, follow the
procedure below.
ALL TRANSMITTER CODES MUST BE LEARNED DURING ONE PROGRAMMING
SESSION.
NOTE: The Unit will learn a total of (2) Pager/Remote-Transceivers only
1. Turn ignition on and off 3 times within 5 seconds leaving it on the 3
chirp should sound if this was performed correctly.
2. Press the override/program button for approx. 5 seconds until 3 siren chirps are heard.
3. Press the (I) button on the transceiver. You should hear a single siren chirp when the code is accepted,
then and press button (I) for an additional transceiver if necessary.
4. Turn the ignition off and wait a few seconds before trying the one or both transceivers.
DIAGRAM:
rd
time. (on/off, on/off, on) A single siren
Advertisement
Table of Contents
