Table of Contents
Advertisement
DISARMING:
Press the (I) button on the remote transceiver. The LCD Display will read "DISARM", the "UNLOCK" icon will appear,
and the remote will emit a 2-beep audible signal. At the vehicle, the siren will chirp (2) times and the lights will flash (2)
times. The red LED in the vehicle will turn off. Doors will unlock and the interior dome light will turn on if these
optional features are installed.
SILENT ARM/DISARM: (Programmable)
The system can programmed to ARM and DISARM silently without Siren Chirps. See programming Option #4. Note:
When programmed for silent ARM/DISARM, the Remote Start confirmation chirps will no longer be heard.
TRIGGERING THE ALARM:
After a short 15 second Arming delay (to allow vehicle/electronics to settle), the system becomes fully armed.
INTRUSION:
If there is an intrusion (door/hood/trunk opening) the alarm will sound with siren, followed 8 seconds later with
alternating light flash / horn honk (optional) for 45 seconds. The 8-second delay before flashing lights/honk is to
allow the control module to transmit signals to the pager/remote. The remote will emit an audible melody, the LCD
Display will tell you which violation has occurred, along with a display icon.
SHOCK/IMPACT:
A hard impact or shock to the vehicle body will trigger the shock sensor and trip the alarm system as listed above.
The LCD will display a moving hammer / glass-break icons. This may or may not mean that there is actually glass
breaking on the vehicle, but it is a reminder to you that a hard impact was detected.
ALARM PRE-WARNING:
If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 5 quick siren chirps and
1 light flash. The remote LCD will read WARN, emit an audible alert, and a flashing a hammer icon. To adjust the
shock sensor, turn its control knob to increase sensitivity or decrease sensitivity.
PANIC FEATURE:
In the event of an emergency situation or to attract attention to your vehicle, press and hold button (I) on the
transmitter for about (5) seconds. The Siren will sound and lights will flash. The LCD remote will emit and audible
alert and the word "PANIC" will display on the screen. Press button (I) again to reset.
VALET MODE:
To disable the Alarm and Remote Start sections of the system while still allowing door lock/unlock, turn the ignition ON
and press the override/program button until the dash LED turns on solid and you hear a siren chirp (about 5 seconds).
Repeat the process to exit valet mode (LED will turn off, lights flash twice, and chirps twice). The word "VALET" will
OPERATION
Advertisement
Table of Contents
