Crestron TPS-XVGAL Operating & Installation Manual page 9

Crestron TPS-XVGAL RGB Computer Interface Card for TPS/Lectern Panel
NOTE: The diagrams in this procedure show a TPS-6000L touchpanel
but the steps for installation into all TPS user interfaces are identical.
This procedure pertains to a unit that is not installed into a wall or
lectern. If already installed, consult the latest revision of the appropriate
operations & installation guide, disconnect power and perform the
installation procedure in reverse to remove the unit. The latest version of
the appropriate guide can be obtained from the Products page
(PRODUCT MANUALS section) or Downloads page (MANUAL
Library) of Crestron's website (www.crestron.com). New users are
required to register in order to obtain access to the FTP site.
Installation Diagram 1 of 7 - Remove Rear Cover Screws
CAUTION: The external connectors of any optional card that is already
installed may have to be aligned slightly to allow the rear cover to be
removed. Align the connectors carefully to prevent damage to the
card(s), cover, or TPS user interface.
Operations & Installation Guide - DOC. 5945
1. To prevent scratching of the screen (TPS-TPI excluded), place
the unit face-down onto a padded surface.
2. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen and remove the 10 screws that secure the rear cover.
RGB Computer Interface Card for TPS/Lectern Panel: TPS-XVGAL • 5