Table of Contents
Advertisement
Crestron TPS-XVGAL RGB Computer Interface Card for TPS/Lectern Panel
Leading Specifications of the TPS-XVGAL (continued)
VisionTools™ Pro-e
Isys Touchpanel Firmware
CEN/CN-TVAV Update File
CNMSX-AV/Pro Update File
CNRACKX/-DP Update File
ST-CP Update File
CNMS, CNRACK, CNLCOMP Operating
System
Max. Input Resolution
Max. Input Refresh Rate
Video Sampling Rate
Dimensions & Weight
1
The latest software versions can be obtained from the What's New page (SIMPL
Windows and VisionTools Pro-e sections) or Downloads page (SIMPLWIN and
VTPRO-E Libraries) of Crestron's website (www.crestron.com). New users are
required to register in order to obtain access to the FTP site.
2
TPS user interfaces with later versions of firmware may include features not
mentioned in this guide. Check the MANUAL Library on the Crestron FTP site
for newer versions of this guide or contact Crestron customer service. Firmware
upgrade files can be obtained from the What's New page (Touchpanels section) or
the Downloads page (TOUCHPNL Library) of Crestron's website.
3
CNX update files are required for either CNMSX-AV/Pro or CNRACKX/-DP.
Filenames for CNX update files have a UPZ extension and ST-CP files are in one
EXE or zipped UPZ file. All can be obtained from the What's New page (Control
Systems Update Files section) or Downloads page (OPSYS Library) of Crestron's
website. Update files are specifically designed for certain control systems. If an
update file is loaded into a control system other than the device for which it was
intended, it may lockup the control system which would then have to be returned
to Crestron. Update files with an "S" designator are for the ST-CP, "V" designator
for CEN/CN-TVAV, "W" for CNRACKX/-DP, and "X" for CNMSX-AV/Pro
control systems. Control systems are able to recognize and reject incorrect update
files. However, when updating control systems, do not ignore any Crestron
Viewport warning prompts or messages.
4
These control systems do not support loading of firmware or VT Pro-e files to the
TPS-series user interfaces through the RS-232 port of the control system. In order
to load these files to the TPS user interface when using these control systems,
either use the RS-232 port on the TPS user interface or use Ethernet direct to the
panel (assuming the TPS-ENETL is installed).
Operations & Installation Guide - DOC. 5945
SPECIFICATION
RGB Computer Interface Card for TPS/Lectern Panel: TPS-XVGAL • 3
DETAILS
Version 2.2.0.0 or later
Version 1.008.0 or later
Version 51233V.UPZ or later
Version 51011X.UPZ or later
Version 51011W.UPZ or later
Version 40104S or later
Version 3.18.09m, l, c or later
1600x1200
85Hz at 1600x1200 Resolution
140MHz (Limited by Crestron)
Height: 1.23 in (3.13 cm)
Width: 3.80 in (9.65 cm)
Depth: 7.01 in (17.80 cm)
Weight: 5.20 oz (0.15 kg)
1
2
3
3
3
3 & 4
3
5
Advertisement
Table of Contents
