Computer Video Connector Signals; Installation And Hookup - Crestron TPS-XVGAL Operating & Installation Manual

Rgb computer interface card for tps/lectern panel
Table of Contents

Advertisement

RGB Computer Interface Card for TPS/Lectern Panel Crestron TPS-XVGAL
5
At the maximum input resolution of 1600x1200, the maximum refresh rate is
85Hz. Lower resolutions may use higher refresh rates.
As of the date of manufacture, the card has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Computer Video Connector Signals

Video Connector Pinouts
HS / CS
1
RGsB (sync on green) is not supported.
2
This connector is not used if composite sync is utilized.

Installation and Hookup

The TPS-XVGAL is designed to be installed into a specific expansion
slot in the TPS user interface. The tools required for installation are a #1
Phillips screwdriver and a grounding strap (or grounded workstation).
CAUTION: The TPS-XVGAL and the TPS user interface contains
electrostatic discharge (ESD) sensitive devices. Perform the following
procedure while wearing a grounding strap that is properly grounded or
on a grounded work station to avoid damaging the card and/or the TPS
user interface.
4 • RGB Computer Interface Card for TPS/Lectern Panel: TPS-XVGAL
PORT
TYPE
R
G
B
VS
Red video input
BNC
Green video input
BNC
Blue video input
BNC
Horizontal sync or composite sync
BNC
BNC
Vertical sync
Operations & Installation Guide - DOC. 5945
SIGNAL(S)
1
2

Advertisement

Table of Contents
loading

Table of Contents