Crestron TPS-IMW Operation Manual page 14

Wall-Mounted Interface Module
Installation into the Electrical Box
The TPS-IMW mounts into a 2-gang electrical box (recommended 2.5"
depth). Verify that the unit is installed into the electrical box as shown in
the following diagram. Secure the TPS-IMW to the electrical box with
the four #6-32 flat-head slotted screws (supplied).
Installation of the TPS-IMW
Once the TPS-IMW is installed into a 2-gang electrical box, it can be
covered with a Decora wallplate (purchased separately).
Remove the backing from the tape on the back of the two silk-screened
insert plates (supplied). Affix each insert plate into its proper opening in
the wallplate. For the proper orientation of the two insert plates with
respect to the installed TPS-IMW, refer to the following diagram.
10 • Wall-Mounted Interface Module: TPS-IMW
Crestron TPS-IMW
Operations Guide – DOC. 5857A