Crestron TPS-IMW Operation Manual page 9

Crestron TPS-IMW
NET/VIDEO Pinouts
TYPE
10-pin RJ-45
Pin 1
To determine the location of pin 1, hold the cable so that the end of the
10-pin RJ-45 connector is facing away from you, with the clip side down
and the copper side up. The copper connector on the far left is pin 1.
CAUTION: The 10-pin RJ-45 net/video connector cable supplied by
Crestron is a custom cable and is the only one that should be used. The
end of the cable has a metal shield that is required to protect the
equipment. Using non-Crestron cables will result in damage to the
product.
AUDIO (To Panel)
AUDIO This 8-pin RJ-45 mates with the TPS-3000, TPS-4000, TPS-5000, or
TPS-6000 touchpanel. The 8-pin audio cable assembly is supplied. Even
1
though the 10-pin net/video cable may fit into the port, do not use it. This
port provides audio input to the touchpanel and microphone output from
the touchpanel. A description of the pinouts is shown in the following
table.
Operations Guide – DOC. 5857A
PIN DESIGNATION
1 +24V
2 GND
3 C+
Pin 1
4 C-
5 Y
6 Z
7 Y+
8 Y-
9 GND
10 +24V
Wall-Mounted Interface Module: TPS-IMW • 5
Wall-Mounted Interface Module
DESCRIPTION
Power (Network)
Ground (Network)
Chrominance (Positive)
/Composite 2
Chrominance (Negative)
/Composite 2
Data (Network)
Data (Network)
Luminance (Positive)
/Composite 1
Luminance (Negative)
/Composite 1
Ground (Network)
Power (Network)