Table of Contents
Advertisement
12 Inch Lectern/Wall Mounted Touchpanel
DIAGNOSTICS MENU
16 • 12 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-5000L
Select the Return button, located at the lower right corner of the Video Menu, after
video parameters have been set.
Diagnostics Menu
The Diagnostics button from the MAIN MENU contains controls for enabling an
Ethernet card (if installed) and diagnostic tools. The diagnostic tools should only be
used under supervision from a Crestron customer service representative during
telephone support. The options available from the DIAGNOSTICS MENU, shown
to the left, are numeric in nature and their interpretation is beyond the scope of this
manual.
NOTE: If the Disable Ethernet button is selected, the touchpanel will not
communicate via TCP/IP or Cresnet Internet Protocol (CIP). Select "Enable
Ethernet" to enable the Ethernet card.
NOTE: The "About..." button will display a screen indicating the current version
of firmware residing on the touchpanel.
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to "Network Wiring" on page 7 before attaching the 4-pin
connector. Apply power after all connections have been made.
CAUTION: Do not apply excessive pressure to the touchscreen display during
handling (mounting/installation). Doing so can crack the screen and damage the
touchpanel.
Hardware Connections for the TPS-5000L (Back of the Unit is Shown)
AUDIO IN
MIC OUT
NET
RS-232
AUDIO INPUT
This 6-position, mini- connector provides line level, balanced and unbalanced audio
input. The pinouts are shown in the tables after this paragraph.
Crestron Isys™ TPS-5000L
NTSC/PAL INPUT
RGB INPUT
C
Y
COMP
+
-
+
- S
S
Operations Guide - DOC. 5783A
Advertisement
Table of Contents
