Setup; Identity Code; Power; Configuring The Touchpanel - Crestron Isys i/O TPMC-4X Operation Manual

Crestron TPMC-4X

Setup

Operations Guide – DOC. 6499

Identity Code

The IP ID is set within the TPMC-4X's table using Crestron Toolbox or during
configuration of the unit in the Setup pages of the TPMC-4X. For information on
setting an IP table, refer to the Crestron Toolbox help file.
The IP IDs of multiple TPMC-4X devices in the same system must be unique. When
setting the IP ID, consider the following:
•
The IP ID of each unit must match an IP ID specified in the SIMPL
Windows program.
•
Each device using IP to communicate with a control system must have a
unique IP ID.

Power

The TPMC-4X is powered via its internal battery. Connect the supplied power
supply to the TPMC-4X-DS docking station.
NOTE: Before using the TPMC-4X for the first time, charge its internal battery for
at least eight hours by placing it in the TPMC-4X-DS docking station.
It takes the TPMC-4X about eight hours to recharge while in use. A fully charged
battery can provide up to three hours of use at the full screen brightness setting.
The battery recharge capacity is 500 cycles to 80% of original capacity.
NOTE: When not using the TPMC-4X, store the unit in its docking station.

Configuring the Touchpanel

When power is applied to the unit for the first time, the following screen appears.
Initial Opening Screen
™
Isys i/O Handheld WiFi Touchpanel
Handheld WiFi Touchpanel: TPMC-4X • 11
™
Isys i/O