Specifications - Crestron QM-RMCRX-BA Operation Manual

Crestron QM-RMCRX-BA
Operations Guide – DOC. 6332

Specifications

Specifications for the QM-RMCRX-BA are given in the following table.
QM-RMCRX-BA Specifications
SPECIFICATION
CPU
Processor Speed
Memory
Power Usage
Initial Firmware Release
Default Network ID
2
Ports/Connectors
LAN
IR (Infrared)
INPUT
COM (A & B)
24 VDC, 2A
CRESNET
VIDEO
S-VIDEO
RGBHV
AUDIO
SPEAKER
QM
RELAY OUTPUT
Reset Buttons
HW-R
SW-R
Composite/S-Video
Video Gain
Bandwidth
RGB Video
Gain
Maximum
resolution/Refresh Rate
H and V Sync
Bandwidth Compensation
Digital Gain Control
Propagation Delay
Compensation
Maximum Compensation
Continued on the following page
1. For more information on system memory usage, refer to "Memory" on page 13.
2. For more information on controls, ports, and indicators, refer to "Physical Description" on page 8.
QuickMedia™ Receiver/Processor: QM-RMCRX-BA • 7
QuickMedia™ Receiver/Processor
DETAILS
32-Bit Motorola 5272 ColdFire
63 MIPS (Dhrystone 2.1 Benchmark)
36 MB (4 MB Flash, 32 MB SDRAM, 256 KB NVRAM)
36 Watts (1.6 A @ 24 VDC)
50 W external power pack (PW-2420RU) included
3.146
02 (Shipped as a control system master)
One RJ-45 10/100 BaseT, full duplex Ethernet port
Default IP Ports: 80 = HTTP/Web Host,
41794 = Crestron, 41795 = Diagnostics/Toolbox
One 2-position mini serial output connector (supports
up to five IR devices)
One 5-position mini digital connector (four inputs plus
ground)
Two DB9 bidirectional RS-232 serial ports, baud rate up
to 115,200 bps (Port B is used for initial communication
and setup)
One DC receptacle for included external power pack
Two 4-pin mini connectors for Cresnet system
One BNC male connector for composite video output
One mini-DIN 4-pin connector for S-video output
One D15HD female connector for RGBHV output
One 9-pin connector for balanced/unbalanced line-level
left, right and speech audio output
Two 2-pin connector for amplified left and right audio
output
One RJ-45 QuickMedia input connector
Two 2-pin mini connectors for relay operation
Initiates system hardware reset
SIMPL Windows program restart (if held at startup,
bypasses program)
0 dB (unity, double termination)
>100 MHz (- 3 dB) at unity gain
0 dB (unity, double termination)
1600 x 1200 @ 60 Hz, at unity gain, with maximum
compensation at receiver
5 V maximum, 100 Ω impedance
p-p
Digital control, 10-bit D/A
10-bit D/A (low frequency compensation)
Digitally controlled delay line (4-bit control)
22 ns (for R, G, or B independently)
®
Processor
1