Table of Contents
Advertisement
Single/Dual-Channel Wireless Mic Receiver
2 • Single/Dual-Channel Wireless Mic Receiver: MP-FS-RX1/RX2
Specifications
Specifications for the MP-FS-RX1/RX2 are listed in the following table.
MP-FS-RX1/RX2 Specifications
SPECIFICATION
Communications
Wireless
RF
IR
Range (typical)
Wired
USB
Audio
A-D/D-A Conversion
Master Volume Range
Bass Gain Range
Treble Gain Range
Ducking Adjustment
Alert Tone
Frequency Response
S/N Ratio
THD+N
Output Power
Amplifier Protection
Power Requirements
Power Pack
Environmental
Temperature
Humidity
Heat Dissipation
Enclosure
Chassis
Faceplate
Mounting
Dimensions
Height
Width
Depth
(Continued on following page)
Crestron MP-FS-RX1/RX2
DETAILS
2.4 GHz ISM Device; 79 channels, FHSS
(2402 to 2480 MHz)
38 kHz (requires MP-FSIR IR Beacon Sensor*)
50 ft (~15 m) indoor, subject to site-specific
conditions
USB host port for firmware update and
configuration
16-bit, 44.1 kHz
-55 dB to +20 dB
±15 dB @ 100 Hz
±15 dB @ 10k Hz
Software adjustable Threshold, Depth, Attack,
and Release
Software configurable functionality
20 Hz to 20 kHz ±0.5 dB
75 dB 20 Hz to 20 kHz A-weighted
0.7% 20 Hz to 20 kHz
15 Watts per channel at 8 or 4 Ohms
Electronic short-circuit and overload protection
2.0 Amps @ 24 Volts DC, 100-240 Volts AC,
50/60 Hz power pack, included
41° to 104° F (5° to 40° C)
10% to 90% RH (non-condensing)
35 BTU/Hr
Metal with polycarbonate label overlay
Plastic with polycarbonate label overlay
Freestanding
2.36 in (60 mm)
8.12 in (207 mm)
5.95 in (152 mm)
Operations & Installation Guide – DOC. 7164B
Advertisement
Table of Contents
