Table of Contents
Advertisement
2015.04.16
5.6 Mode 6
D = decrease value
I & D
D 2s = empty value
I = increase value
I 2s = empty value
In steps of 5
D = decrease value
I & D
D 2s = empty value
I = increase value
I 2s = empty value
In steps of 5
I & D
D = decrease value
D 2s = empty value
I = increase value
I 2s = empty value
I & D
D = decrease value
D 2s = empty value
I = increase value
I 2s = empty value
I & D
D = decrease value
D 2s = empty value
I = increase value
I 2s = empty value
E =save entry
Actions need to be stored/saved individually
(up until R31 at least; change request pending)
Settings can only be stored if position information available.
The stairlift can be driven to next setpoint while in menu using special drive-in
joystick (not via buttons, UI or C&P, only drive-in joystick)
Driving stops automatically at next stored position of the setting selected.
10 stop positions can be stored as either Halt or Park (so H00 and P00 do not
simultaneously exist)
If the system gets to the negative charging contact and sees the reset, it shows
rSt and resets it's position.
Learn rail mode
Mode 6
1:Enter speed S - -, S05 ... S100
E =save entry
2:Enter angle A - -, A-110 ... A110
E =save entry
3:Enter halt H - -, H00 ... H09
E =save entry
4:Enter park P - -, P00 ... P09
E =save entry
5:Enter rotate R - -, R-110 ... R110
www.ThyssenKruppAccessibility.com
Flow2 - Stairlift
E 2s
E 2s
E 2s
E 2s
E 2s
Save entry
Main menu
Tab 06: Systematic fault finding
*PING*
-6-
Advertisement
Table of Contents
