Table of Contents
Advertisement
2015.04.16
4.3 Warning messages
These codes are used to draw the technician's attention to certain conditions.
When these warnings are generated they don't stop the lift and the user will not be aware of these.
However, they are shown in the display on the service board and can be seen in the error log in mode
-9- (except C04).
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Warning code
Warning message
Description
Safety action
Possible solution
Warning suppressed in
Flow2 - Stairlift
C04
Tilt > 2⁰
Chair is more than 2⁰ out of level
Reduce speed
Program correct speed in rail data
Mode -3- / ELD mode
C56
Unexpected negative charging contact
An unexpected reset contact was detected
Report the warning
Mode -3- / ELD mode
C58
Negative charging contact expected
A reset contact was expected but not detected.
Report the warning
Mode -3- / ELD mode
C60
Position outside max. rail length
The maximum raillength is 45 m.
Report the warning
Mode -3- / ELD mode
C61
Unexpected reset point swivel
The zero opto has been detected at an unexpected position
Report the warning
Mode -3- / ELD mode
C62
Inverted zero opto signal swivel
Signal goes from high to low instead of from low to high or vice versa.
Report the warning
Mode -3- / ELD mode
www.ThyssenKruppAccessibility.com
Tab 06: Systematic fault finding
Advertisement
Table of Contents
