Create A User-Defined Fixture - Crestron D3 PRO Reference Manual

Software
24 • Crestron D3 Pro™

Create a user-defined fixture

1. Open the desired library, Global or Project. As described earlier, global
fixtures are available to any project you create on your computer, while
project fixtures are available only in the current project.
2. Right-click a fixture category and select Add.
3. Enter the name of the fixture and select a load type from the list.
4. Enter the fixture wattage. This is the default, per fixture, wattage.
5. For lighting loads, you can select advanced light properties. First, select or
clear the Dimmable check box.
If the lighting load is dimmable, you can enter Upper Limit and Lower
Limit values, which define the lower and upper light levels for dimming.
That is, Upper Limit is the maximum intensity that the controlled circuit can
achieve regardless of the programmed level. A circuit with an upper level of
95% will never get brighter than 95%, even if a button has been programmed
to set that light to 100%.
Similarly, Lower Limit is the minimum intensity prior to shutting off. If a
button has been programmed to set the level to less than the lower limit, the
light will stay at the lower limit, unless the light is instructed to go to 0%, at
which point it will turn off.
Crestron D3 Pro
Reference Guide – DOC. 5998a
™