Crestron D3 PRO Reference Manual page 66

Software
62 • Crestron D3 Pro™
However, if you had set Upper Limit and Lower Limit values in the Advanced
Lighting properties of the Load Schedule View, then those Upper Limit and Lower
Limit values override the Target value and affect the fade time as well. In the
example below, if you had set an Upper Limit value of 80%, the lights will reach
their maximum level (80%) in 4 seconds.
S
WITCHED DEVICES
Switched devices such as pumps or fans have two commands, On and Off. Both are
"rising edge" digital commands that switch the device on or off. Here again, some
devices might require a pulse time.
3-W M
IRE OTORS
3-Wire motor devices such as drapes have the following digital commands: Open,
Close, Stop, Jog Open, Jog Close, Open_Momentary, and Close_Momentary.
The Open and Close commands move the motor in the open or close direction to their
maximum setting. The Jog Open and Jog Close commands move the motor in fine
increments. Recall that if you select a Jog Time in the Advanced Motor Properties
section of the Load Schedule View, you were specifying how long the Jog Open and
Jog Close commands would activate the motor. The Jog Open and Jog Close inputs
will remain high for <Jog Time> seconds, to a maximum of 2.00 seconds. Similarly,
the Max Time advanced motor property affects the Open and Close commands. The
Stop command halts operation of the motor. The Momentary commands move the
motor in the indicated direction for as long as the button is pressed.
V S
ACATION CHEDULER
The D3 Pro Vacation Scheduler has three commands: Record, Play and Stop. The
Record command sets the Vacation Scheduler to record light levels at specified
intervals. The Play command plays back the recorded light levels, typically when the
resident goes away. The Stop command halts recording or playback. The Vacation
Scheduler is described in detail later in this section.
Crestron D3 Pro
Reference Guide – DOC. 5998a
™